Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 14 replies
  • Subscribers 14 subscribers
  • Views 592 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PCB design

Carey Bunks
Hi all,


I'm looking for some help with PCB design.  Specifically, I'd like to collect data from a large number of MEMS microphones mounted on a single board.  The mics are PDM devices that are clocked at about 3mHz, and then downsampled to 16 bit samples at 48kHz.  At 3mHz, I'm concerned that the wires will act like antennas, and interfere with each other.  Can anyone advise on best practice (or provide a reference)?


Cheers,

 

Carey
  • 0
    Sorry to intervene but could this discussion not be done offline however interesting it may be!
  • 0
    I agree, this isn't a place for technical discourse. My iet email is alex.barrett@ietvolunteer.org
  • Former Community Member
    0 Former Community Member
    Please also note. The mental processes for designing an Electronic circuit and that required for designing a PCB is completely different.
  • 0
    As the Russians would say, “Da nyet”. They are different skills but I wouldn't want to lay out a circuit without some knowledge of the operation of that circuit.

Community Rules & Guidelines