Open delta thyristor control why use 6 wires

Stephen Biddle over 5 years ago

Hi All

I work on large heaters, which are 3 phase delta, no neutral. Most of the systems use thyristors to control 2 or 3 legs, so far so good only three cables to the heater. Some systems use 3 thyristor connected in series with each phase ie 6 wires. Why is this done? It doubles the cable cost.

Regards

Stephen

Parents

0 Legh Richardson over 5 years ago

Hi Stephen,

I have had no practical experience of heavy duty resistive element heaters but looked interesting so had a sniff around and found this link.

http://www.libratherm.com/pdf/(21.5.1)3%20PHASE%20THYRISTOR%20POWER%20PACKS%20POW-12%20(3%20to%2015%20KW).pdf

It appears to be direct thyristor power control of the heating elements. The number of conductors seems to be more like 12 rather than 6 although perhaps one side are taken out to monitor and feedback by a closed loop process control circuit.

Legh
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Legh Richardson over 5 years ago

Hi Stephen,

I have had no practical experience of heavy duty resistive element heaters but looked interesting so had a sniff around and found this link.

http://www.libratherm.com/pdf/(21.5.1)3%20PHASE%20THYRISTOR%20POWER%20PACKS%20POW-12%20(3%20to%2015%20KW).pdf

It appears to be direct thyristor power control of the heating elements. The number of conductors seems to be more like 12 rather than 6 although perhaps one side are taken out to monitor and feedback by a closed loop process control circuit.

Legh
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Open delta thyristor control why use 6 wires

Join us to get the best from IET EngX.

Community Rules & Guidelines