This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reducing the fuel consumption of ships

We could greatly reduce the fuel consumption and emissions of ships if we used the energy of waves. This could done by adding a pipe all the way around the ship above sea level. Water enters the pipe at the bow and exits at the stern to push the ship forward. The pipe is higher and wider at the bow than the stern. Waves force water into one way openings at the bow to give pressurised water with potential energy. This pressurised water forces jets of water out at the stern.

All the pipework is above sea level so ships could be retroftted without the need to go into dry docks. There is no change to the laminar flow of water below sea level.

The motion of the ship adds to the kinetic energy of waves. By diverting this energy around the ship we can reduce drag and fuel consumption. This would be a low cost way to reduce greenhouse gas emissions without the need for people to reduce their standards of living.

Parents
  • Former Community Member
    0 Former Community Member

    An interesting concept.

    Would the addition of a pipe to the ship not ruin it's streamlined design and introduce more drag and increase the power requirement to move through the water? I'm thinking that the bow is rather smooth and sharp to cut through the water more easily.

    I also think that a ‘passive pipe’ wouldn't be very useful for propulsion. I use the phrase ‘passive pipe’ as opposed to that of say a jetski where water is forced through. What about adding a dynamo into the pipe to generate power from the water rushing through it (assuming that water does enter the pipe)?

    Could we perhaps tow a series of turbines behind the ship which generate electricity? (Again adding drag, of course)

    I'm no expert (not even an amateur really), just my stream of thought…

Reply
  • Former Community Member
    0 Former Community Member

    An interesting concept.

    Would the addition of a pipe to the ship not ruin it's streamlined design and introduce more drag and increase the power requirement to move through the water? I'm thinking that the bow is rather smooth and sharp to cut through the water more easily.

    I also think that a ‘passive pipe’ wouldn't be very useful for propulsion. I use the phrase ‘passive pipe’ as opposed to that of say a jetski where water is forced through. What about adding a dynamo into the pipe to generate power from the water rushing through it (assuming that water does enter the pipe)?

    Could we perhaps tow a series of turbines behind the ship which generate electricity? (Again adding drag, of course)

    I'm no expert (not even an amateur really), just my stream of thought…

Children
No Data