Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 14 replies
  • Subscribers 14 subscribers
  • Views 597 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PCB design

Carey Bunks
Hi all,


I'm looking for some help with PCB design.  Specifically, I'd like to collect data from a large number of MEMS microphones mounted on a single board.  The mics are PDM devices that are clocked at about 3mHz, and then downsampled to 16 bit samples at 48kHz.  At 3mHz, I'm concerned that the wires will act like antennas, and interfere with each other.  Can anyone advise on best practice (or provide a reference)?


Cheers,

 

Carey
Parents
  • 0
    I've recently done some signal distribution across 100 devices, but converted to differential pairs for transmission, as this is much more benign than a single-ended signal flapping about. What are your distances between devices & source?
Reply
  • 0
    I've recently done some signal distribution across 100 devices, but converted to differential pairs for transmission, as this is much more benign than a single-ended signal flapping about. What are your distances between devices & source?
Children
No Data

Community Rules & Guidelines