This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Connecting Multiple Bemco/Ryefield Boards

Ok I have a new build project where one Bemco/Ryefield board is not large enough to cover all apartments.

I will need to install 3 to cover the number of outgoing ways required.

My questions is this. Given that there is one incoming bulk supply, what options are there to split it between the three? I know Lucy do an MSDB with a vertical busbar. Would the DNO accept daisy chaining these together? Or should we use a busbar chamber and tap-off to each board?

Any advice would be gratefully received.

Parents

0 GHEC over 5 years ago

John Peckham:

I have designed quite a few blocks of flats from low rise up to 2 x 40 story modular builds.

How many flats per floor and how many floors. Anything else to be. Supplied such as gym, laundry, shops etc?

Hi

There are 36 flats in total. Car park and entrance lobby on the ground floor, 10 flats on the 1st, 2nd and 3rd floors. The remaining flats on the 4th floor.

Only other things of note are a couple of EV charging points.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 GHEC over 5 years ago

John Peckham:

I have designed quite a few blocks of flats from low rise up to 2 x 40 story modular builds.

How many flats per floor and how many floors. Anything else to be. Supplied such as gym, laundry, shops etc?

Hi

There are 36 flats in total. Car park and entrance lobby on the ground floor, 10 flats on the 1st, 2nd and 3rd floors. The remaining flats on the 4th floor.

Only other things of note are a couple of EV charging points.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Connecting Multiple Bemco/Ryefield Boards

Community Rules & Guidelines