This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

The last remaining domestic circuits without RCD protection.

I prepared an EICR this morning for a two bed flat.


The peak installation has a 30 mA RCD main switch, which surprisingly despite being more than ten years old is a type A, so no RCD issues there.


The off-peak supplies two storage heater circuits run in surface mounted plastic mini trunking without RCD protection, so again no RCD issues. If I were installing the storage heaters with new circuits I would install RCD protection, but there’s no reason to condemn an existing installation.


I am just pondering exactly what can be installed in a domestic installation now without any RCD protection with the 18th Edition of the Wiring Regulations making them a requirement on lighting circuits there cannot be much left on the list.


 Andy B.
Parents
  • What about a split-load board, so the light above the consumer unit is on the other RCD from the light in the room or hallway that the cubpoard, alcove etc is in, so there's always some light even with a fault causing the tripping of one RCD?
Reply
  • What about a split-load board, so the light above the consumer unit is on the other RCD from the light in the room or hallway that the cubpoard, alcove etc is in, so there's always some light even with a fault causing the tripping of one RCD?
Children
No Data