Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 13 replies
  • Subscribers 32 subscribers
  • Views 911 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Current carrying capacity of the wires inside a fluorescent batten with regard to LED tubes

psychicwarrior
Hello all - good afternoon !


As in the subject, can someone verify please what the current carrying capacity of the [thin] wires in a flourescent batten is ?


It is with regard to fitting an LED tube replacement where the [electronic] ballast has to be taken out of circuit; the wires from it to one of the tube mount ('tombstones' ?)  have to be cut and wired from the tube mount directly back to the 240V supply, according to most instructions.


I was curious about the wires with regard to doing this - it must be ok as this is the general instruction, but I was interested to know what they can carry.
Parents
  • 0
    @gkenyon -  yes I think one has to conclude that the OEM certifications are void.


    Most LED tube kits either make use of the internals as they are (no mods) when a magnetic ballast and starter a    re present (just using a replacement starter) ie. just fit the tube.


    If electronic internas (no starter/electronic ballast) then everything has to be removed and the LED tube itself is the only active component.


    In both cases I think the LED tube manfacturers instructions for the product and fitting become relevant and the batten is just a mounting facility for the LED tube - which the manufacturer, one would presume, is stating is suitable for their product when their instructions are followed.


    The wires being resused in the batten just need to be verified as suitable in my view - electrically - as the supply to the LED tube.
Reply
  • 0
    @gkenyon -  yes I think one has to conclude that the OEM certifications are void.


    Most LED tube kits either make use of the internals as they are (no mods) when a magnetic ballast and starter a    re present (just using a replacement starter) ie. just fit the tube.


    If electronic internas (no starter/electronic ballast) then everything has to be removed and the LED tube itself is the only active component.


    In both cases I think the LED tube manfacturers instructions for the product and fitting become relevant and the batten is just a mounting facility for the LED tube - which the manufacturer, one would presume, is stating is suitable for their product when their instructions are followed.


    The wires being resused in the batten just need to be verified as suitable in my view - electrically - as the supply to the LED tube.
Children
No Data

Community Rules & Guidelines