Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Helpful Answer
  • Locked Locked
  • Replies 13 replies
  • Subscribers 31 subscribers
  • Views 1898 views
  • Users 0 members are here
Options
You may also be interested in
This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Subwoofer humming

Lisa Miles
Well the OH finally installed the surround sound system he's been wanting to do for many months now (God help our neighbours...) but when the subwoofer is turned on, it's rather audibly humming like a Tibetan Monk!


A quick look on Google for a solution mentions that it may be because it's plugged into it's own socket outlet?? ?


Can anyone explain why this would cause the sub to hum? 


As an Audio expert Martin Russ‍ can you provide any insight?
Parents
  • +1
    It presumably stops humming if you unplug it, so in a sense correct.

    When folk come up with this sort of thing there is usually a grain of truth behind  it, but not well explained

    How does the signal that is to be amplified get to it ? I assume via a screened audio cable, and if so, are the earths of the equipments at the two ends at the same voltage -  every microvolt counts here - if one end puts out  an audio signal of say 10mV RMS relative to its earth, and the  other amplifies and plays the voltage it sees relative to its earth, but the two nominal zero volt earths are actually some mV apart, then the ampifier sees the signal and the extra ground slope voltage as being in series. The chances of the two chassis voltages being different is increased if they are plugged into different places, so putting them onto a common 4 way block in a single socket tends to help, by reducing the voltage difference between the '0V ' ends of the link.


    PS LISA  is this post in the right bit of the fourm. ?
Reply
  • +1
    It presumably stops humming if you unplug it, so in a sense correct.

    When folk come up with this sort of thing there is usually a grain of truth behind  it, but not well explained

    How does the signal that is to be amplified get to it ? I assume via a screened audio cable, and if so, are the earths of the equipments at the two ends at the same voltage -  every microvolt counts here - if one end puts out  an audio signal of say 10mV RMS relative to its earth, and the  other amplifies and plays the voltage it sees relative to its earth, but the two nominal zero volt earths are actually some mV apart, then the ampifier sees the signal and the extra ground slope voltage as being in series. The chances of the two chassis voltages being different is increased if they are plugged into different places, so putting them onto a common 4 way block in a single socket tends to help, by reducing the voltage difference between the '0V ' ends of the link.


    PS LISA  is this post in the right bit of the fourm. ?
Children
No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Join us Not now

Community Rules & Guidelines