This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Fire alarm panel supply

Good morning.

I have a question that may sound silly so excuse my ignorance in advance

I have a Fire Alarm Panel

This is going to be fed through FP200.

However the installation of the FP200 would need an RCD because it is chased within a stud wall less than 50mm from the surface.

Can I omit the RCD on the grounds that it is a critical system for the safety of people?

Is there anything like that in BS7671?

It seems really counter intuitive to use an RCD on a Fire Alarm Panel...

Thanks
Parents
  • Former Community Member
    0 Former Community Member

    Apostolos Kasinalis:

    OMS, sorry I am not so advanced in my knowledge around the regulations.

    As I understand there is no provision in BS7671 to omit an RCD in case of a safety or a critical system. Am i right?

     




     

    It depends on what it's wired in, and how as discussed and described in several posts above.


    Personally speaking, I would use all of the available mechanisms to omit the RCD protection from a life safety system


    Regards


    OMS
Reply
  • Former Community Member
    0 Former Community Member

    Apostolos Kasinalis:

    OMS, sorry I am not so advanced in my knowledge around the regulations.

    As I understand there is no provision in BS7671 to omit an RCD in case of a safety or a critical system. Am i right?

     




     

    It depends on what it's wired in, and how as discussed and described in several posts above.


    Personally speaking, I would use all of the available mechanisms to omit the RCD protection from a life safety system


    Regards


    OMS
Children
No Data