This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wiring diagram

Former Community Member
Former Community Member
Anyone out there with a great mind for heating systems, care to draw me a wiring diagram ?


There is a

-warm flow oil boiler 

-Immersion 

-pipe stat 

-UFH Valve

-Manifold(8 zones)

-Hot water valve

-Hot water circulation 

-Towel warmer valve (stat is what’s on the towel rail)

-Upstairs heating valve

-2 x 2 channel Honeywell programmer

-1x 1 channel Honeywell programmer

-1x stat for upstairs radiators

-stat for each ufh zone 


Any advice on what I can use to get this all linked together, currently looking at S plan but I feel someone with experience with similar system  may give some better guidance 


Clint



Parents
  • Just google 'S Plan +'  there are 100's of wiring diagrams.

    So you have the following valves:

    UP CH, Down CH, HW, Towel rail, UFH. 5 valves, so nothing too difficult.

    You will need at least one stat for each of those. The UFH stat is probably included in the UFH kit/controller.

    Is it really going to be a circulatory HW system? Is the house huge?

    That is normally only used for large commercial systems.
Reply
  • Just google 'S Plan +'  there are 100's of wiring diagrams.

    So you have the following valves:

    UP CH, Down CH, HW, Towel rail, UFH. 5 valves, so nothing too difficult.

    You will need at least one stat for each of those. The UFH stat is probably included in the UFH kit/controller.

    Is it really going to be a circulatory HW system? Is the house huge?

    That is normally only used for large commercial systems.
Children
No Data