Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 32 subscribers
  • Views 566 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Dating existing electrical installations by type of cable

Dave Thomas
Modern pvc T&E cables 4mm and below are a  usually single solid conductor, but going back a few years ring mains were regularly installed with either 2.5mm ( or possibly older imperial  cables?) that were multi stranded conductors. Does anyone know, was there a date, or edition of the good book, when this changed, and at what point was metric mmsq specified instead of the older wire gauge?

.
Parents
  • 0
    I believe that the old imperial sized cable used for ring circuits was 7/.029 inches. That is 7 strands of 0.029 dia. inch wires per live and neutral conductor, the earth wire being smaller. An old text book I have states that the 7/.029 conductor of rubber insulated cables had a nominal area of .0045 square inches and a resistance of 5.374 Ohms per 1,000 yards at 20 degrees C. Popular in the 50s and 60s, but the insulation was changed to P.V.C. latterly. The book I have says that a British Standard, No.7 of 1953 refers to the insulation thickness of rubber cables, it refers to the insulation as "dielectric." Tinned copper was used with rubber insulation to protect the copper from attack by sulphur I believe in the rubber insulation.


    Z.
Reply
  • 0
    I believe that the old imperial sized cable used for ring circuits was 7/.029 inches. That is 7 strands of 0.029 dia. inch wires per live and neutral conductor, the earth wire being smaller. An old text book I have states that the 7/.029 conductor of rubber insulated cables had a nominal area of .0045 square inches and a resistance of 5.374 Ohms per 1,000 yards at 20 degrees C. Popular in the 50s and 60s, but the insulation was changed to P.V.C. latterly. The book I have says that a British Standard, No.7 of 1953 refers to the insulation thickness of rubber cables, it refers to the insulation as "dielectric." Tinned copper was used with rubber insulation to protect the copper from attack by sulphur I believe in the rubber insulation.


    Z.
Children
No Data

Community Rules & Guidelines