This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Obvious departures from the regulations at first glance at a new consumer unit.

I was asked to give an EICR on an domestic property which is to be placed on the market (part P applicable). I found that a builder as part of the other renovation work, (new doors, windows and kitchen etc.) has carried out the installation of a new metal consumer unit. On first opening this dual RCD unit, the 2 lighting circuits were on one R.C.D., and the 2 final ring circuits on the other R.C.D,, it was obvious also, that some wires to the new CB's were short and not lengthened, resulting in a bird's nest at the M.C.B.''s.


Plainly, a qualified electrician hadn't carried out the work. What would the readers as registered electricians have done ?. 1. Walk away. 2. Propose to have an E.I.C.R. carried out (UNSATISFACTORY), then carry out the rectification work and issue MWC's.3. Rectify the obvious departures, issue M.W.C.'s and then issue a SATISFACTORY E.I.C.R. 


Jaymack
Parents
  • commonly seen but the bus bar is not tapered, so you could do it either way.

    One of the older Wylex hot wire fuseboards had some beefed up brass works to the first position, and this was the only one supposed to take more than  a 30A fuse - used when showers and larger cookers came in. There may be some collective memory.
Reply
  • commonly seen but the bus bar is not tapered, so you could do it either way.

    One of the older Wylex hot wire fuseboards had some beefed up brass works to the first position, and this was the only one supposed to take more than  a 30A fuse - used when showers and larger cookers came in. There may be some collective memory.
Children
No Data