The IET is carrying out some important updates between 17-30 April and all of our websites will be view only. For more information, read this Announcement

Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 12 replies
  • Subscribers 31 subscribers
  • Views 5082 views
  • Users 0 members are here
Options
You may also be interested in
This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Crimping of flexible cord conductors

PG
Like most of us, I often crimp flne strand conductors, especially for screw terminals but do not do this for domestic lamp holders and roses etc.

I thought that I would check Section 526 (Electrical Connections) of the Regs but did't find a clear statement of requirements for crimped ends. 

I was particularly unsure of what 526.9.1 was specifying for fine wire conductors "conductor ends shall be suitably treated".


Any guidance or comment would be appreciated.


Regards
Parents
  • 0
    Sparkingchip:

    I replaced a consumer unit, the guy who had installed the previous consumer unit had used insulated boot lace ferrules on the 25 mm meter tails inside the 35 mm cage terminals of the main switch.


    I just pulled the ferrules off with my fingers and threw them away, they had not been crimped with a tool and even if they had I don’t think it would have made much difference. 

     


    I seem to recall that Hager supplied a pair of ferrules, for fitting to the main switch, with their consumer units, for a short period of time, in the 1990s.


Reply
  • 0
    Sparkingchip:

    I replaced a consumer unit, the guy who had installed the previous consumer unit had used insulated boot lace ferrules on the 25 mm meter tails inside the 35 mm cage terminals of the main switch.


    I just pulled the ferrules off with my fingers and threw them away, they had not been crimped with a tool and even if they had I don’t think it would have made much difference. 

     


    I seem to recall that Hager supplied a pair of ferrules, for fitting to the main switch, with their consumer units, for a short period of time, in the 1990s.


Children
No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Join us Not now

Community Rules & Guidelines