I have found a fan
MONSOON ZONE 1 SILENCE TIMED EXTRACTOR FAN MON-S100T
it is main powered, I can’t do a 12v as there is No where the transformer can go.
is the monsoon okay to use? It says zone 1?
Clint:
I have no where for the transformer to go, it won’t have an 3point isolation point. It will be straight from light fitting and will come off once the light is off. There is no way to get a 3core from switch without destroying the room. It’s a flat roofed , no access from above the room, joists run across meaning a big strip would need to be taking out of ceiling along with a chase down the wall to the switch. So going from the light fitting to the fan is only way without destroying my house. The fan is at opposite side of bath, so about 1m from shower and about 1.5m from bath bowl.
The original question was he has found a fan "Monsoon MON-S100T" and goes on to say the above. I have read the instructions. After reading the instructions for the fan, and without at least a minimum a switched fuse spur, this will not comply with manufacturers instructions, and to comply with current wiring regulations you must follow manufacturers instructions.
So to simply answer the original question without means of isolation, no its not ok to use the Monsoon MON-S100T fan, forget any other regulation it may or may not comply with.
Clint:
I have no where for the transformer to go, it won’t have an 3point isolation point. It will be straight from light fitting and will come off once the light is off. There is no way to get a 3core from switch without destroying the room. It’s a flat roofed , no access from above the room, joists run across meaning a big strip would need to be taking out of ceiling along with a chase down the wall to the switch. So going from the light fitting to the fan is only way without destroying my house. The fan is at opposite side of bath, so about 1m from shower and about 1.5m from bath bowl.
The original question was he has found a fan "Monsoon MON-S100T" and goes on to say the above. I have read the instructions. After reading the instructions for the fan, and without at least a minimum a switched fuse spur, this will not comply with manufacturers instructions, and to comply with current wiring regulations you must follow manufacturers instructions.
So to simply answer the original question without means of isolation, no its not ok to use the Monsoon MON-S100T fan, forget any other regulation it may or may not comply with.
We're about to take you to the IET registration website. Don't worry though, you'll be sent straight back to the community after completing the registration.
Continue to the IET registration site