This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Pulsing LED Strip on dimmer?

Fitted some IP rated LED strip in a bathroom controlled by a dimmer. When turned right down to low level, the led strip pulses dim/bright.

Strip is Aurora/Eternal, approx 3 metres in total and is supplied via a Aurora EN-LEDD7512 Triac LED driver rated at 75W max. This is controlled by a Varilight GPJJ100W dimmer switch which is supposedly programmable. Tried the methods described in the dimmer switich installation instructions but no joy.

Any ideas?
Parents
  • Hi Mike,

    Thanks for your input. Reading down a bit reveals the following - Note the last line - not suitable for triac type drivers. Not sure what the difference is between a VPRO and a VCOM.

    Might try mode 2 just to see if it makes any difference.
    THIS SWITCH IS NOT SUITABLE FOR
    Non-dimmable LED lighting
    Non-dimmable fluorescent bulbs and tubes
    Wire-wound or toroidal transformers
    Electric motors (e.g. Fans)
    TRIAC dimmable drivers (Choose V-Com series dimmers)
Reply
  • Hi Mike,

    Thanks for your input. Reading down a bit reveals the following - Note the last line - not suitable for triac type drivers. Not sure what the difference is between a VPRO and a VCOM.

    Might try mode 2 just to see if it makes any difference.
    THIS SWITCH IS NOT SUITABLE FOR
    Non-dimmable LED lighting
    Non-dimmable fluorescent bulbs and tubes
    Wire-wound or toroidal transformers
    Electric motors (e.g. Fans)
    TRIAC dimmable drivers (Choose V-Com series dimmers)
Children
No Data