Relocation of kitchen so let etc

Former Community Member over 4 years ago

Hi all was wondering what you all do when asked to relocate sockets during a kitchen refit, specifically where you have made a joint in an existing 2G backbox which is no longer going to be used?

Do you just fit a blanking plate over, let the tiler tile over or terminate in wago connectors and let the plaster bury the joint?

Regards Ts

Parents

0 Former Community Member over 4 years ago

Thanks for all the replies guys.

I'm going to cut out some glav trunking lid and screw in place over the 2G and 1G back boxes has required before they get over boarded. Have taken photo of prior to making good and will include this with the rest of the documentation. The existing cable is already protected by steel capping and a upfront RCD. The plate will give a similar degree of protection has the capping. So should be sufficient along with all the other measures.

Regards Ts
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Former Community Member over 4 years ago

Thanks for all the replies guys.

I'm going to cut out some glav trunking lid and screw in place over the 2G and 1G back boxes has required before they get over boarded. Have taken photo of prior to making good and will include this with the rest of the documentation. The existing cable is already protected by steel capping and a upfront RCD. The plate will give a similar degree of protection has the capping. So should be sufficient along with all the other measures.

Regards Ts
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Relocation of kitchen so let etc

Community Rules & Guidelines