Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 23 replies
  • Subscribers 32 subscribers
  • Views 1796 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

12 volt outside light recommendations.

Former Community Member
Former Community Member
Hi all. I am in the process of turning my front garden into a driveway. Now on the side of this drive way is a brick wall where I want to put 3 x 12 volt wall lights. I have excavated the ground and dug a trench and put some 20mm conduit for now. What I want to know is are there outside lights that don't come pre wired? I don't want to have any junction boxes on the wall or buried in the ground. Can the electrician wire it with loop in loop out so the only connections are at the light fitting itself so no connections underground etc.


I hope that makes sense.


Regards Lee
Parents
  • 0
    You definitely would not be able to dig into this with a spade or a pick axe. So I think it is pretty well protected from mechanical damage.

    That kind of material is quite usual to dig through when a new or replacement pipe or cable is needed - it needn't be just hand tools either - a kanga breaker or similar would quite reasonably be employed. In most cases nothing beats earthed armour/metallic sheath for saving lives if the cable is struck by a metallic tool.


    I'd also avoid "U" shapes of conduit/ducting with no drainage - whatever you do they tend to fill with water, and most cables aren't suitable for permanent immersion.


    Don't forget some warning tape above the buried section of the cable either.


        - Andy.
Reply
  • 0
    You definitely would not be able to dig into this with a spade or a pick axe. So I think it is pretty well protected from mechanical damage.

    That kind of material is quite usual to dig through when a new or replacement pipe or cable is needed - it needn't be just hand tools either - a kanga breaker or similar would quite reasonably be employed. In most cases nothing beats earthed armour/metallic sheath for saving lives if the cable is struck by a metallic tool.


    I'd also avoid "U" shapes of conduit/ducting with no drainage - whatever you do they tend to fill with water, and most cables aren't suitable for permanent immersion.


    Don't forget some warning tape above the buried section of the cable either.


        - Andy.
Children
No Data

Community Rules & Guidelines