The IET is carrying out some important updates between 17-30 April and all of our websites will be view only. For more information, read this Announcement

Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 19 replies
  • Subscribers 31 subscribers
  • Views 2617 views
  • Users 0 members are here
Options
You may also be interested in
This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Wago’s pull test

Baldyhugh
Hi all.

I've been using wago’s for a couple of years now and more recently the 221 series mainly on lighting circuits. As I do with all terminations, I do a gentle ‘pull test’ after connection which was drummed into me from apprenticeship days to check if the wire is securely held. I also do this with the wago’s but on occasion find that the wire will pull back slightly but not pull out. It can then be pushed forward again fully up into the terminal. I find that this happens more with solid conductors rather than stranded or flex. My query is, am I damaging the internal workings of the wago by carrying out this pull test? I like the reassurance of a pull test on terminations but should it be given a miss on wago’s?


thanks in advance
Parents
  • 0
    Chris -

    No, the sockets were not available to fit - Click brushed stainless range and wholesaler was out of them, so I thought I could at least get the testing done. New ring installed by myself a week before so all good. To begin with, I suspected dodgy cable but all was ok once I repeated the tests without the WAGOs. Had a similar problem with r1+ r2 on the new lighting cct too. readings swinging wildly, so much so that I thought my test leads or croc clips were dodgy. I swappped out the WGAO and went old school with a 15A screwed connector and all calmed down. - I use a Fluke 1520 ohm meter with IR range - no all-in-ones for me!
Reply
  • 0
    Chris -

    No, the sockets were not available to fit - Click brushed stainless range and wholesaler was out of them, so I thought I could at least get the testing done. New ring installed by myself a week before so all good. To begin with, I suspected dodgy cable but all was ok once I repeated the tests without the WAGOs. Had a similar problem with r1+ r2 on the new lighting cct too. readings swinging wildly, so much so that I thought my test leads or croc clips were dodgy. I swappped out the WGAO and went old school with a 15A screwed connector and all calmed down. - I use a Fluke 1520 ohm meter with IR range - no all-in-ones for me!
Children
No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Join us Not now

Community Rules & Guidelines