Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 43 replies
  • Subscribers 32 subscribers
  • Views 9845 views
  • Users 0 members are here
Options
You may also be interested in
This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Twin immersion heaters

Former Community Member
Former Community Member
I am in the process of going unvented.  I have to use immersion heaters, and the new cylinder has two.  I have one feed to the existing immersion.  It is on 2.5mm2 T&E and connects to a 32A MCB on the CU.  I'm adding a DP isolating switch in the cylinder cupboard.  Will that be complaint for one of the immersion heaters?

To fully install the cylinder (ie the second immersion), I plan ask an electrician to either
(1) run an additional 2.5mm2 T&E cable back to the CU, connect it to the existing 32A immersion heater MCB at the CU. So the MCB protects two separate cables and the 2.5 T&E is within its capacities. 

Or
(2) run a new 6mm2 T&E cable back to the CU, connect to the existing MCB and in the cylinder cupboard, split the feed to two DP isolators, one for each immersion and its timer.


I'd be grateful for advice - are both approaches compliant?  Is one better than the other?  The amount of work will be similar.
Parents
  • 0
    You should not be using both immersion heaters at the same time, just one or the other. Neither of the plans appear sensible.


    Depending on if you have a two tariff supply or not and how the consumer unit is configured, one circuit may supply both being switched from one to the other or it may be beneficial to install two circuits if you have a peak and off peak consumer unit.


    So what tariff are you on and how many consumer units are there?
Reply
  • 0
    You should not be using both immersion heaters at the same time, just one or the other. Neither of the plans appear sensible.


    Depending on if you have a two tariff supply or not and how the consumer unit is configured, one circuit may supply both being switched from one to the other or it may be beneficial to install two circuits if you have a peak and off peak consumer unit.


    So what tariff are you on and how many consumer units are there?
Children
No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Join us Not now

Community Rules & Guidelines