Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 24 replies
  • Subscribers 32 subscribers
  • Views 3171 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Old incomer connected to four 3 phase cutouts help

Simon M
Hi all,


I have a very old incomer entering the building that then feeds to 4 x 3ph cutouts. You can see two of the 3ph cutouts in the pic.
9f8642aebed8db60e40f7a2578ffd3a3-original-02.jpg


The incomer says on it  - BI Callender's - 4E 150 x 3. I assume this means 3 x 150 Amps? Please do correct me if I am wrong.


1. What is the maximum power I can draw from this system?


2. If each of the 4 Three phase cutouts were loaded with 100 Amp fuses and I was to pull close to that from each fuse. what would happen to the incomer as this would equate to 1200 Amps!


3. Is connecting 4 3ph cutouts to this old beast a reasonable thing to do? Or is it ridiculous?


Many thanks

Simon
Parents
  • 0
    Simon M:

    I do have the DNO coming out in an attempt to try and get them to upgrade the incomer but I'm not holding my breath.


    If they say that it will be fine for the intended use, what is there to complain about?


Reply
  • 0
    Simon M:

    I do have the DNO coming out in an attempt to try and get them to upgrade the incomer but I'm not holding my breath.


    If they say that it will be fine for the intended use, what is there to complain about?


Children
No Data

Community Rules & Guidelines