Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 16 replies
  • Subscribers 32 subscribers
  • Views 1256 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bonding.......again

Former Community Member
Former Community Member
Hi,


I have recently carried out an EICR on a property which probably had been victim to the Bathroom fitter. It previously has an electric shower which had been removed along with new fixtures and fittings including light and fan. They have left in a supplementary bond from the pull cord to one of the incoming pipes from the heating to the towel radiator.

Now then - My proposal, as there is no supplementary bonding (other than the pullcord to radiator), is to move the lighting circuit for the bathroom (upstairs) onto the RCD side of the CU as the Ze for the circuit complies and the Main Protective Equi Bonding is in place. I have measured low ohms between all pipework and it is 0.02 or lower. This is a more suitable solution than running a 4mm to every point.


My question is what do I do with the bond from the switch to the heating pipe? Do I leave it in or disconnect it. 


Many thanks for your time.


Chris
Parents
  • 0
    I believe that the concern is that the answers to the original questions are clearly stated in the regs. that Chris posted above. One about main equipotential bonding, and the second specifically about bonding in bathrooms or shower rooms. We should all have this basic understanding if we carry out periodic inspections and issue E.I.C.Rs. But I suppose on site we may wish to get an instant answer if we have left our regs. book at home, which is naughty.


    This kind of lack of knowledge of basic stuff casts a doubt on our ability to function properly if we don't know the answers. I admit that we can not know everything and sometimes we may forget stuff. 


    When I carry out inspection and testing, I write down rough notes on a pad. I then have the opportunity to look up Regs. about things if I am not certain, before I issue a full formal E.I.C.R.


    Reaching a high level of acquired knowledge and maintaining our awareness of updates and current requirements is essential to us working safely and competently.


    Z.
Reply
  • 0
    I believe that the concern is that the answers to the original questions are clearly stated in the regs. that Chris posted above. One about main equipotential bonding, and the second specifically about bonding in bathrooms or shower rooms. We should all have this basic understanding if we carry out periodic inspections and issue E.I.C.Rs. But I suppose on site we may wish to get an instant answer if we have left our regs. book at home, which is naughty.


    This kind of lack of knowledge of basic stuff casts a doubt on our ability to function properly if we don't know the answers. I admit that we can not know everything and sometimes we may forget stuff. 


    When I carry out inspection and testing, I write down rough notes on a pad. I then have the opportunity to look up Regs. about things if I am not certain, before I issue a full formal E.I.C.R.


    Reaching a high level of acquired knowledge and maintaining our awareness of updates and current requirements is essential to us working safely and competently.


    Z.
Children
No Data

Community Rules & Guidelines