The IET is carrying out some important updates between 17-30 April and all of our websites will be view only. For more information, read this Announcement

This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Plug in RCD 230V or 110V transformer

Former Community Member
Former Community Member
I'm curious to see what peoples opinions are on the two different options available for safer power tool use either using 110V tools with a site transformer alone or 230V tools however using these with the plug in RCD. 


I'm aware of the center tapped site transformer splitting the voltage into 55V so there is the arguement that it's only 55V pushing through your body, vs the RCD option, you're exposed to the potentially full 230V but the RCD cuts the supply almost instantly. However this is based on the RCD actually working and detecting a fault and even if it does perhaps even that brief exposure to 230V may be enough for some people to be fatal. Then again 55V maybe enough for some people too to be fatal. 


Thought?


Parents
  • What amazed me in many cases on site, was the use of a very long 240 Volt extension lead to a 110 Volt yellow box transformer, the 240 Volt lead running  over piles of bricks, across an access route for vehicles, through puddles and having been buried by a pile of sand, then a drill was plugged into the yellow box at the remote end.


    Z.
Reply
  • What amazed me in many cases on site, was the use of a very long 240 Volt extension lead to a 110 Volt yellow box transformer, the 240 Volt lead running  over piles of bricks, across an access route for vehicles, through puddles and having been buried by a pile of sand, then a drill was plugged into the yellow box at the remote end.


    Z.
Children
No Data