This discussion is locked.

You cannot post a reply to this discussion. If you have a question start a new discussion

Consumer Unit Blanking Plates

Former Community Member over 3 years ago

It is conceivable that a loose live conductor could come into contact with a metal blanking plate. Some of the twist-on types do not make electrical contact with the (earthed / powder-coated) case in which case they thus constitute exposed conductive parts. This means that they should be individually earthed. But there is no means provided to do do this. So the question is: does the use of metal CU blanking plates contravene the Wiring Regulations if fitted but not earthed?

Parents

0 Zoomup over 3 years ago

I recently installed a new all R.C.B.O. consumer unit for a local customer. The metal board had an earth tail from the front cover to the earth terminal. A blighter if you forget it's there and wonder at just what is holding the cover back when you try to remove it. No blanks, all R.C.B.O.s.

Z.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Zoomup over 3 years ago

I recently installed a new all R.C.B.O. consumer unit for a local customer. The metal board had an earth tail from the front cover to the earth terminal. A blighter if you forget it's there and wonder at just what is holding the cover back when you try to remove it. No blanks, all R.C.B.O.s.

Z.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Consumer Unit Blanking Plates

Community Rules & Guidelines