Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 12 replies
  • Subscribers 32 subscribers
  • Views 1808 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Has anybody used these matt-e products for EV charging points?

Former Community Member
Former Community Member

Is this brand any good ? 

The supply source is a three phase T-N-C-S system. The load on the three phase distribution board is never going to be fully balanced so the options are to either to install earthing rods (electrode) or use one of these devices to avoid hammering rods to be compliant.

Just wondered if anyone had any experience with the brand.

Any other ideas also welcomed.

Regards,

J

 

Parents
  • 0

    I suspect that in practice this is achievable only with a row of EVCPs along the side of a factory.

    Or is the assumption that the EVSE load will be negligible compared to the balanced load of the factory?

    Yes, that was my thinking.

Reply
  • 0

    I suspect that in practice this is achievable only with a row of EVCPs along the side of a factory.

    Or is the assumption that the EVSE load will be negligible compared to the balanced load of the factory?

    Yes, that was my thinking.

Children
No Data

Community Rules & Guidelines