This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Electrician fined for EICR.

https://www.pembrokeshire.gov.uk/newsroom/electricians-guilty-plea-over-report-signing-off-unsatisfactory-electrics

Parents
  • Chris Pearson: 
     

    perspicacious: 
    If someone were to put a nail into the cable just under the surface, would that be safe or dangerous?

    So, BOD, are you saying that any non-RCD protected circuit with cables in walls is a C2?

    The newspapers are not exactly full of stories of people who have succumbed whilst putting nails in walls. Perhaps that is more by luck than judgement?

    I suspect that most 40 - 50 year old houses would have had wooden floors and that cables would approach sockets from below so no risk from picture hooks there. Light switches are invariably in corners so you couldn't put anything but a very small picture there. And then if you tried to hit the line conductor, which is less than 2 mm across, with a nail of a similar size you would probably fail.

     

    OK, I shouldn't post this BUT… here goes! 

    Last year I took the rear of my property apart. Knocking down walls' and moving the W.C., etc. When I was removing the rear section I found… a rawl plug, and screw, through the centre, (oh dear), of the oval conduit, that had a 3 core,(and earth), PVC cable in it!!! It had been there for over 35 years'!!! The lighting system still worked BUT, I guess these things happen! Oooops!

    regards… 

Reply
  • Chris Pearson: 
     

    perspicacious: 
    If someone were to put a nail into the cable just under the surface, would that be safe or dangerous?

    So, BOD, are you saying that any non-RCD protected circuit with cables in walls is a C2?

    The newspapers are not exactly full of stories of people who have succumbed whilst putting nails in walls. Perhaps that is more by luck than judgement?

    I suspect that most 40 - 50 year old houses would have had wooden floors and that cables would approach sockets from below so no risk from picture hooks there. Light switches are invariably in corners so you couldn't put anything but a very small picture there. And then if you tried to hit the line conductor, which is less than 2 mm across, with a nail of a similar size you would probably fail.

     

    OK, I shouldn't post this BUT… here goes! 

    Last year I took the rear of my property apart. Knocking down walls' and moving the W.C., etc. When I was removing the rear section I found… a rawl plug, and screw, through the centre, (oh dear), of the oval conduit, that had a 3 core,(and earth), PVC cable in it!!! It had been there for over 35 years'!!! The lighting system still worked BUT, I guess these things happen! Oooops!

    regards… 

Children
No Data