Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 34 subscribers
  • Views 458 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wet Bathroom Towel Rail Fault.

Zoomup

Good day all,

   A customer reported that her towel rail did not heat up when using the electric heating element of her towel rail. It heats up via the gas boiler though. Upon investigation I found that the electric element was open circuit. But, to replace the element the towel rail needs to be drained down. That's a plumbers job, I am not going to do that. Also, there are no isolation valves for the tower rail.  Modern designs can be a pain. The towel rail is quite new and has had little use. I don't think that the element has been used dry. I wonder if the installer has dropped the towel rail onto the electrical connection located bottom right. Perhaps a plumber could freeze the pipes to allow the element to be replaced?

Z.

Parents
  • 0

    Zoomup,

    Having been in my house a number of years, I know any attempt for appropriate reasons to drain down my heating system is an absolute pain, due to a very bad section of pipework that airlocks and stops correct filling back up again, so much so local plumber will not work on my house as it took him a full day, all sorts of hoses stuck in here there and everywhere to get it eventually filled correctly. 

    Anyway few years ago got the main bathroom refitted and of course my other half wanted a whole new heated towel rail, plus old one needed to come off to allow tiling removal and application. Also old towel rail didnt have any isolation valves either.

    Mentioned issues about drain down to the bathroom fitting company and was told not to worry, he lifted the floor in that section and froze the pipework to the towel rail, not only did that allow safe removal of the old towel rail, he also fitted isolation valves on new bits of pipework coming thru the floor all ready for new heated towel rail to go on when tiling had been done, so perhaps that can be done in your situation?

     

    Cheers GTB 

Reply
  • 0

    Zoomup,

    Having been in my house a number of years, I know any attempt for appropriate reasons to drain down my heating system is an absolute pain, due to a very bad section of pipework that airlocks and stops correct filling back up again, so much so local plumber will not work on my house as it took him a full day, all sorts of hoses stuck in here there and everywhere to get it eventually filled correctly. 

    Anyway few years ago got the main bathroom refitted and of course my other half wanted a whole new heated towel rail, plus old one needed to come off to allow tiling removal and application. Also old towel rail didnt have any isolation valves either.

    Mentioned issues about drain down to the bathroom fitting company and was told not to worry, he lifted the floor in that section and froze the pipework to the towel rail, not only did that allow safe removal of the old towel rail, he also fitted isolation valves on new bits of pipework coming thru the floor all ready for new heated towel rail to go on when tiling had been done, so perhaps that can be done in your situation?

     

    Cheers GTB 

Children
No Data

Community Rules & Guidelines