Is this an example of over tightening?
Also some E.V. charger point testing at the end. Very interesting.
Z.
Is this an example of over tightening?
Also some E.V. charger point testing at the end. Very interesting.
Z.
These are presumably the proper glass-fibre loaded nylon glands, and not the cheap all-plastic ones that jump threads. The torque can be high then.
some makers data
Click on the table to enlarge. Asuming that is M25 or so, then 7.5nm is about 6ft pounds so he is probably overdoing it a bit, but not b so much, hand pressure on a 10 inch spanner not held at the ends.
These are presumably the proper glass-fibre loaded nylon glands, and not the cheap all-plastic ones that jump threads. The torque can be high then.
some makers data
Click on the table to enlarge. Asuming that is M25 or so, then 7.5nm is about 6ft pounds so he is probably overdoing it a bit, but not b so much, hand pressure on a 10 inch spanner not held at the ends.
We're about to take you to the IET registration website. Don't worry though, you'll be sent straight back to the community after completing the registration.
Continue to the IET registration site