Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 37 subscribers
  • Views 822 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Failed Niglon B20 M.C.B.

Zoomup

A Niglon B20 M.C.B. has failed after about ten years use. It protected a summer house and small potting shed. The summer house has a 2.5kW space heater in it and the potting shed a small frost heater of about 750 Watts. The breaker became unreliable and stopping passing current but had not tripped off.

What would cause this to happen. Surely if overloaded the breaker would just trip off and not become damaged internally? Or would it? Could the contacts become damaged by over currents just below the tripping threshold, but above the current rating of the contacts?

Z.

Parents
  • 0

    Where is this? The main CU? If so, perhaps as Mike says an odd failure.

    If it's in an outbuilding, and not in an IP-rated consumer unit, external influences could be an issue. IP55 would give a longer life in outbuildings, but even then condensation occasionally might be an issue that causes early failure dependent on ventilation and actual location.

  • 0 in reply to gkenyon

    The M.C.B. was located in a new garage unit in a potting shed outdoors. The enclosure does show some signs of external  rusting but the innards are dry and are not affected.

    Z.

  • 0 in reply to Zoomup

    Just because the innards look dry doesn't mean mildew etc. haven't formed inside the device, and that there is no dust in there.

    It's difficult without being able to forensically examine it.

    For example, you say the outside has rust, but not the inside (e.g painted surfaces) ... but what about springs etc. in side the mcb?

Reply
  • 0 in reply to Zoomup

    Just because the innards look dry doesn't mean mildew etc. haven't formed inside the device, and that there is no dust in there.

    It's difficult without being able to forensically examine it.

    For example, you say the outside has rust, but not the inside (e.g painted surfaces) ... but what about springs etc. in side the mcb?

Children
No Data

Community Rules & Guidelines