Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Helpful Answer
  • Locked Locked
  • Replies 18 replies
  • Subscribers 38 subscribers
  • Views 3844 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ElectricalOM Source setup.

richard64

Are there any ElectricalOM users on here who can explain setting up the source details?

Thank you.

Parents
  • 0

    yes - what info are you looking for?  Alternatively contact the EOM helpdesk.  They are really responsive

  • 0 in reply to chrisbryant

    Hi Chris, 

    The Helpdesk is really good. The issue is that the source is defined by the substation information, which is normally unavailable or difficult to obtain. I'm trying to get the source to be the origin of the installation, the service head, but it's not easy to input the correct Ze and PFC. 

    I was given a workaround by using an unknown source component, but it's not really ideal.

Reply
  • 0 in reply to chrisbryant

    Hi Chris, 

    The Helpdesk is really good. The issue is that the source is defined by the substation information, which is normally unavailable or difficult to obtain. I'm trying to get the source to be the origin of the installation, the service head, but it's not easy to input the correct Ze and PFC. 

    I was given a workaround by using an unknown source component, but it's not really ideal.

Children
  • 0 in reply to richard64

    Hi Richard,  do you know the Ze and PSC values but don't know how to enter them?  Or is your issue the fact that you don't have the information and therefore don't know wheat to enter?  

  • 0 in reply to chrisbryant

    Hi Chris, I have Ze and PEFC and PSCC values. The system I'm working on is TT as well, which isn't a help. But even with TN systems, it's not obvious. The guy from technical help told me to get the transformer values and % and use them...for my next trick I'll nail jelly to the ceiling.

  • 0 in reply to richard64

    I would set the source type transformer.  I would set it to user defined source and the earthing system to TT and then enter the values in the relevant box:

  • 0 in reply to chrisbryant

    Unfortunately that doesn't work.

    Neither does adding the Ze value as the earth electrode resistance.

  • 0 in reply to richard64

    I've a Ze of 23.6 and a PSCC of 10.17. 

  • 0 in reply to richard64

    Hi Richard,

    What doesn't work?  Are the values in the data entry tab correct, but the values not being used in the calculation?

  • 0 in reply to richard64

    That must be an L-N PSSC (assuming kA for the 10.17, i.e. about 20 milliohms round the L~N loop - so close to the TX or a fairly bosky feed cable, )  and an L-E of course for Ze inlcudes the terra-firma path.

    All sounds very sensible for a TT installation with decent electrode hence the 20 odd ohms, some at the load end electrode, some at the transformer earthing.

    M.

Community Rules & Guidelines