Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 17 subscribers
  • Views 489 views
  • Users 0 members are here
Options
You may also be interested in
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unconventional lighting project.

Legh Richardson
Good evening all,

A friend has given me a beast of a thermonic valve, a half-wave rectifier, RG4-3000, to turn into some sort of table lamp.

Access appears to be somewhat tricky as i'd need to remove the glass envelope. I remember removing the envelope of a smaller glass tube pentode when I was 15-16 years of age to produce a scaled technical drawing, but for the life of me I can't remember whether or not I broke the glass asm I never bothered to replace it..

My question is, has anybody attempted anything similar and how did they remove the glass envelope in tact so that it could be attached at a later time?

Legh

regards to all and thanks for reading

Parents
  • 0
    This is a low pressure gas filled valve (aids anode cooling)

    There will be a gas fill tube 'pinch' usually under the valve base, but not always. Should look like a length of glass tube filed flat.

    Masking tape on the exposed part, and then use a triangular file or a diamond cutter to slowly cut though the tape and the glass to reuinite the atmosphere and the vacuum until it just starts to hiss .  (tape stops the crack from 'running' )

    To open the depresuried envelope in a big way I am less sure. In the days of CRT regunning, a hotwire cutter would be used to cause a fine line of local stress and to 'plink' a straight cut that could then be re-sealed with a glass lathe.
    about 30-40 seconds into this video shows that.

    I suspect/fear  no-one except perhaps university chemistry dept technicians has this kit or the ability nowadays.

    Goggles, gloves,  and somehere that  sweeping up if it all goes wrong can be done easily, so perhaps not the kitchen..



    Folk who cut thick walled bottles use a jig holding a glass cutter to create a uniform scratch around the circumference - a variation on that method may be worth considering, and perhaps combining with the thermal shock technique
Reply
  • 0
    This is a low pressure gas filled valve (aids anode cooling)

    There will be a gas fill tube 'pinch' usually under the valve base, but not always. Should look like a length of glass tube filed flat.

    Masking tape on the exposed part, and then use a triangular file or a diamond cutter to slowly cut though the tape and the glass to reuinite the atmosphere and the vacuum until it just starts to hiss .  (tape stops the crack from 'running' )

    To open the depresuried envelope in a big way I am less sure. In the days of CRT regunning, a hotwire cutter would be used to cause a fine line of local stress and to 'plink' a straight cut that could then be re-sealed with a glass lathe.
    about 30-40 seconds into this video shows that.

    I suspect/fear  no-one except perhaps university chemistry dept technicians has this kit or the ability nowadays.

    Goggles, gloves,  and somehere that  sweeping up if it all goes wrong can be done easily, so perhaps not the kitchen..



    Folk who cut thick walled bottles use a jig holding a glass cutter to create a uniform scratch around the circumference - a variation on that method may be worth considering, and perhaps combining with the thermal shock technique
Children
No Data

Community Rules & Guidelines