Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Helpful Answer
  • Locked Locked
  • Replies 4 replies
  • Subscribers 16 subscribers
  • Views 1769 views
  • Users 0 members are here
Options
You may also be interested in
This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Energy Smart Meter Installation- All needed tests, inspection and wiring regulations

Fener Hemedo

Hello everyone!
I am just asking about the following 
- The wiring regulations for the installation

- The needed inspection, tests and maintenance

for both three phase and single phase installation

Thanks

Parents
  • +1

    replacing existed meter to a new smart energy meter

    It'll usually be done according to the supplier's own rules (which will be based on basic legislation, ( ESQCR, H&S@W etc) and established industry practice. As has been said, it normally doesn't fall within BS 7671 (but might occasionally - e.g. where there's a building network). The last few times I seen anything done, on-site inspection & testing consisted of a quick polarity check and taking a photo. Even if it did fall under BS 7671 a simple meter swap would be minor works and wouldn't require anything like the the full set of tests.

       - Andy.

  • 0 in reply to AJJewsbury

    Thanks a lot

Reply Children
No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Join us Not now

Community Rules & Guidelines