More wind farms, or more reliable sources of renewables.

With the talk of easing planning for on-shore wind farms, and with “Greens” pushing for less reliance on fossil fuels or nuclear, even more emphasis is being placed on wind as a major source of energy.  A look at Gridwatch shows that there has been only minor contribution of wind to the UK Grid Demand since August 23rd.  Fortunately, at the moment demand is fairly low and solar has made a contribution during the day but that is not always the case.  Is it not time that much more investment is made into more reliable sources of renewables, we seem to be working ourselves into a corner?

Parents
  • Should we consider ion harvesting as a technology that can complement other renewable energy sources such as wind and solar

Reply
  • Should we consider ion harvesting as a technology that can complement other renewable energy sources such as wind and solar

Children
  • In the UK the average ion flux is such that we get a few pA  (yep  I do mean 1E-12 Amps) per square meter of sky facing ion collection surface, and the typical voltage gradient is about 100V per metre of altitude. 

    On a bone dry day. Rather less when its raining. a million times more in a thunderstorm but not for long at a time.

    Put another way if you could connect to a perfectly insulated catcher 100m up (10kV) of say 10m by 10m (100m2 capture area) you have a few hundred picoamps times 10kV - some milliwatts.

    The problem is building supports for your collectors well enough insulated to not leak it all away before you can use it.  There is a lot of wild balony written about this sort of thing on the internet so be careful.

    An amusing DIY project ?

    https://rimstar.org/science_electronics_projects/corona_motor_electrostatic_atmospheric_motor.htm

    Mike

  • Hi Mike. This is what I read: The ICM is a special type of carbon nanomaterial that can harvest electricity from atmospheric ions. The wire is a conductor that connects the ICM to the ground station. The ground station is a device that converts, stores and uses the electricity harvested by the ICM. The atmosphere is the source of atmospheric ions that power the ICM. The ICM is exposed to the air using a balloon or a kite. The ICM forms an electron cloud around itself when it encounters atmospheric ions. This electron cloud increases the conductivity of the air around the ICM and causes electrical current to flow, driven by the atmospheric voltage. The current travels along the wire to the ground station. The ground station has three parts: a power converter, a hydrogen generator and a battery. The power converter converts the high-voltage alternating current (AC) from the ICM to a low-voltage direct current (DC) that can be used or stored. The hydrogen generator uses some of the electricity to split water into hydrogen and oxygen gas. The hydrogen gas can be stored or used as fuel. The battery stores the excess electricity for later use. 

  • There is no doubt that microscopically hairy surfaces make better ion collectors and emitters than perfectly smooth ones and they claim the space charge is less likely to repel incoming charges. I'm not so sure of that, but the high field gradients exist where no of ions available is smallest, as that is where the air is not so conducting it all leaks away. Here, (Hants) the air has a time constant of about 10-20 minutes at the moment - that is the capacitance of a unit volume (about 0.1pF) versus its resistance (say about 10^16 ohms across the faces of the same 1cm cube.)

    I am aware of work published in the stormier parts of Florida that have occasionally harvested a few orders of magnitude more at times of windy weather, but it is still  fractions of a watt from massive installations, compared to say solar power.

    https://9a099e.a2cdn1.secureserver.net/wp-content/uploads/2017/11/Economic-model-study-Rev-B-authored-by-Dr.-Phil-Metzger-PhD.pdf

    is probably the most enthusiastic about  it.

    Mike

  • I appreciate the link you sent me. It is a very intriguing and exciting idea. The author is hopeful about the technology and its potential. However, there are some technical and regulatory challenges that need to be addressed before ion power can be widely implemented. These include enhancing the design and performance of the ion collectors, developing efficient and reliable systems for power conversion and transmission, ensuring the safety and security of the ion power infrastructure, and obtaining the necessary permits and approvals from the authorities.