I have a customer who wishes to remove the redundant storage heater points and plaster over. The house has recently had a new CU (not by me) and and gas central heating and the now redundant storage heating cables are left gently blowing in the wind in a cupboard. Wrapped in duct tape. Nice. Instinctively I do not like leaving redundant cables lying about and I certainly don't like finding them. However, as I will be able to identify both ends of said cables what is the general view to cutting them off in the cupboard and plastering in the old storage heater points?
They could have been converted into single sockets. I'd just fit a new blank plate over the old storage heater points if they really aren't needed, then perhaps slosh a bit of emulsion over them. Job done. Mr. Perfection me!
They could have been converted into single sockets. I'd just fit a new blank plate over the old storage heater points if they really aren't needed, then perhaps slosh a bit of emulsion over them. Job done. Mr. Perfection me!
