This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Schneider/Telemecanique Zelio-Logic smart relay

Hi all,

first post to the new look forum. Does anyone have experience of the above ( the one I need info on is a model which has been superseded).

One of the perameters needs to be changed and I need to know if this can be done directly on the unit itself or if software is required.

Either way I’m going to have to get someone in to do it, as I have no plc experience, but I’d like to know in advance what’s actually involved.

Thanks in advance for any info.
Parents
  • Former Community Member
    0 Former Community Member
    I'm not afraid of a soldering iron either Mike, but, when you look at the time it takes to research the right pin out's, source the materials to make the lead, and make it, you could have been earning money at your normal charge rate, so it is often just not economically viable to make them, just buy the damn thing use it, charge for the job and move on to the next one and get paid again instead of spending an hour making a lead that costs less than you could have earned in that hour, iykwim! ;)

    I agree this is not always the case too.
Reply
  • Former Community Member
    0 Former Community Member
    I'm not afraid of a soldering iron either Mike, but, when you look at the time it takes to research the right pin out's, source the materials to make the lead, and make it, you could have been earning money at your normal charge rate, so it is often just not economically viable to make them, just buy the damn thing use it, charge for the job and move on to the next one and get paid again instead of spending an hour making a lead that costs less than you could have earned in that hour, iykwim! ;)

    I agree this is not always the case too.
Children
No Data