This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Immersion heater - economy 7 timer wiring

Former Community Member
Former Community Member
Hello,


I have a honeywell st6400c controller and an immersion heater. 

My heater has 2 switches, off and on peak. My concern is that the heating works only with both switches on. Even if its set to trigger at off peak time only, which it does, both switches light up and if I switch off the onpeak one, the heating stops even tho the offpeak is still lit (testing this at off peak hours ofc). Is this correct ? does this not use much more electricity? I was monitoring this and Im sure it goes against the "night" hours, but my worry is that it uses much more power than it should.

Thank you for your advice

Tom
Parents
  • Former Community Member
    0 Former Community Member
    Ive even trained myself to be using all appliances over night, resp early in the morning. washing machine, dishwasher, laptop charging etc, all happens during night rate as i think the e7 would be useless without doing so.

    the 1h and 20 minutes makes enough water for shower and general use considering my gf doesnt spend 1 hour in the shower singing lol
Reply
  • Former Community Member
    0 Former Community Member
    Ive even trained myself to be using all appliances over night, resp early in the morning. washing machine, dishwasher, laptop charging etc, all happens during night rate as i think the e7 would be useless without doing so.

    the 1h and 20 minutes makes enough water for shower and general use considering my gf doesnt spend 1 hour in the shower singing lol
Children
No Data