The IET is carrying out some important updates between 17-30 April and all of our websites will be view only. For more information, read this Announcement

Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 31 subscribers
  • Views 1461 views
  • Users 0 members are here
Options
You may also be interested in
This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Water heater. Correct cable to use

Baldyhugh
Hi all


I have a large 6kw water heater to connect at a farm for washing a bulk milk storage tank. It is made made by Cotswold heaters and consists of a large insulated tank inside an outer steel box. It is controlled by separate control box containing timers and a contactor and connections for solenoids and a float switch. In the heater itself it is prewired to some din rail mounted style connectors to then accept the incoming cables. The prewired cables from the block to the heater terminals are heat resistant and the other smaller cables to the solenoid and float switch appear to be so aswell. My question is should the incoming cables be heat resistant as they don’t connect directly to the heater element terminals. If it was just a standard heater I would use a single heat resistant flex but there are control cables aswell with just a single cable entry to the heater so I was going to use flexible conduit and singles from the control box to the heater. I have wired a few of these before this way and the cables have been ok years later but in the spirit of bettering my methods I was wondering what way others would attack this job. Would some heat resistant sleeving over the singles at the heater End suffice or where should the requirement for heat resistant cables begin and end? See picture of heheater, sorry about the quality. The heater is at the bottom and connections are all behind the clear Perspex cover, hopefully the picture explains what I’m on about
Parents
  • 0
    I maintain a similer boiler for a farmer. It must be at least 30 years old and I did not install it. 


    None of the supply cables are heat resistant. With the exception of the supply to the heater none of the internal cables are heat resistant and some have been replaced over the years when contractors or thermostats have been replaced with different items with different wiring configurations. None are showing any heat damage. 


    As the maximum water temp used will be about 80 - 90 degrees and the tank is insulated, the temp in the connection/controller box should never get near this and I doubt any of the components around the connections are rated at more than 70 degrees. As the manufacturers instructions make no reference to using heat resistant cable or sheathing, I would not worry about using standard cable.


Reply
  • 0
    I maintain a similer boiler for a farmer. It must be at least 30 years old and I did not install it. 


    None of the supply cables are heat resistant. With the exception of the supply to the heater none of the internal cables are heat resistant and some have been replaced over the years when contractors or thermostats have been replaced with different items with different wiring configurations. None are showing any heat damage. 


    As the maximum water temp used will be about 80 - 90 degrees and the tank is insulated, the temp in the connection/controller box should never get near this and I doubt any of the components around the connections are rated at more than 70 degrees. As the manufacturers instructions make no reference to using heat resistant cable or sheathing, I would not worry about using standard cable.


Children
No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Join us Not now

Community Rules & Guidelines