This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

13A EV socket

TNCS system in local development. Second hand BMW 330E Hybrid with ICCB that appears to restrict charging to 6A. Owner wants 13A socket on outside wall of house. 

The area is near the Mourne mountains where an Ra of 200 ohms would be difficult to achieve with a single rod. In any event the driveway has just be nicely finished. It would be a simple matter of drilling through the back of the meter cupboard to provide  the 13A socket but it is the loss of neutral protection that is the problem. Anyone know if loss of neutral protection is available as a separate item?
Parents
  • Yes, there are options.


    One manufacturer has a single-phase device that aligns with 722.411.4.1 (iii).


    There are a number of other manufacturers producing devices to achieve 722.411.4.1 (iv).


    As with anything, some are better than others. Of course, the devices can't "comply with BS 7671" as you're well aware, so I would check their DofCs (see section 5.3.5.1 of the IET CoP for EV Charging Equipment Installation, 4th Ed, for guidance on this).
Reply
  • Yes, there are options.


    One manufacturer has a single-phase device that aligns with 722.411.4.1 (iii).


    There are a number of other manufacturers producing devices to achieve 722.411.4.1 (iv).


    As with anything, some are better than others. Of course, the devices can't "comply with BS 7671" as you're well aware, so I would check their DofCs (see section 5.3.5.1 of the IET CoP for EV Charging Equipment Installation, 4th Ed, for guidance on this).
Children
No Data