This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Theoretically optimal location of a distribution substation

Former Community Member
Former Community Member
Hello, 
I have the following problem with the preliminary design stage of a residential area:

The software I use can calculate a theoretically optimal location of a distribution substation for low-voltage networks. This place is calculated as a "center of power demand" or "center of gravity" of electrical consumers.

If the substation locates in this optimal place, we can design 0.4kV distribution feeders with a minimum length and power losses in low-voltage feeders are minimal. 

I understand it’s almost impossible to put it exactly there, and I consider some sites nearby. But the architect believes that this is unacceptable in terms of landscape design and wants to place the substation in a far corner.

Who should be the arbiter in this situation?  DNO representative takes a neutral position.  Local authorities are completely on architect side, they do not care that long power cables will heat the atmosphere for many years to come.

3602925e57eac86d03447a5e59fc8e9b-huge-image.png
Parents
  • True OMS, but I have never seen many of these appliances in 3 phase variants. The air-con and heating probably yes, but washing machines etc? Anyway, there is little reason not to over-design here a bit, they are big houses and the extra cable and fuses will simply reduce losses, which is what the OP wants.


    Regards

    David
Reply
  • True OMS, but I have never seen many of these appliances in 3 phase variants. The air-con and heating probably yes, but washing machines etc? Anyway, there is little reason not to over-design here a bit, they are big houses and the extra cable and fuses will simply reduce losses, which is what the OP wants.


    Regards

    David
Children
No Data