Hi guys iv been asked to help with a lighting sollution at this large family home
They currently have 2 sensors (x2 and x3) connected in parallel controlling 2 lights (□1 and □2) - they would however like to add an additional 2 sensors (x1 and x4) and also a switch (● 1) to bring on the lights as when required (but not to switch the circuit off)
Adaptable box (■ 1) currently have the L - N - E - SW
I would like to bring 3 individual switch wires from the 2 new sensors and 1 new switch back to the adaptable box
We will then have the following number of cables in each connector block
L - 4 wires
SW - 5
N - 4
E - 5
LIght 1 - 100w LED Flood
Light 2 - 200w LED Flood
Can anyone suggest a better way of doing this or is this method acceptable?
I feel a little apprehensive about all the cables in together but also don't feel it would be unsafe - just not ideal.
Any input winputted greatly appreciated.
I will also try add a picture of the plan.
