You cannot post a reply to this discussion. If you have a question start a new discussion
how to put rcd and rcbo in Paul consumer unit
Former Community Member
so I need to put an RCBO into a British General 16-Module 10-Way Populated High Integrity Dual RCD Consumer Unit (2920G) it has three neutral bars so that fine the issue is how to connect the buzz bar that will supply the RCBO and the cable that takes power to the RCD feed in and connect them at the outlet of the main switch I've done a mock up on a board I have at home and have used an MCB instead of an RCBO as I haven't Brought it yet but would this be ok if not how do I get round it???
