The IET is carrying out some important updates between 17-30 April and all of our websites will be view only. For more information, read this Announcement

Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 94 replies
  • Subscribers 31 subscribers
  • Views 5902 views
  • Users 0 members are here
Options
You may also be interested in
This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Installation of a generator for a house.

Tomgunn
Hello all,


I'm moving house, (been here for over 42 years'!!), and one of the first items on my mind is installing an electrical generator.


SO; I guess there will be contactors / switch gear etc as I would like it to be 'automatic', (OR, maybe 'manual' too), changing from incoming to the generator.


a; What would be the best type of generator to purchase? Load wise? I'm not too worried as the bigger the load the bigger the           generator would need to be as long as I could run the basics within the house.


b; What switch gear would be appropriate?


I would't fancy the idea of switching tails around on a Henley block each time I needed the generator to be in use!!


Thanks, in advance!


regards... Tom
Parents
  • 0
    mapj1:

    It is quite possible to stall a lightly loaded generator without operating any MCBs or fuses. (on at least one model it is also possible to shear a pin in the drive train by applying a short circuit when near full load one,  when the throttle is at max to maintain the revs, but that is another embarrassing story.)


    davezawadi (David Stone):

    Going on to CPDs, a 5kVA machine would probably stall on a ring short before it popped a type B ...

    Well, that shear pin was in there for a reason. ?


    It's a bit like letting the clutch out a bit swiftly at the bottom of Sutton Bank. ?


Reply
  • 0
    mapj1:

    It is quite possible to stall a lightly loaded generator without operating any MCBs or fuses. (on at least one model it is also possible to shear a pin in the drive train by applying a short circuit when near full load one,  when the throttle is at max to maintain the revs, but that is another embarrassing story.)


    davezawadi (David Stone):

    Going on to CPDs, a 5kVA machine would probably stall on a ring short before it popped a type B ...

    Well, that shear pin was in there for a reason. ?


    It's a bit like letting the clutch out a bit swiftly at the bottom of Sutton Bank. ?


Children
No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Join us Not now

Community Rules & Guidelines