The IET is carrying out some important updates between 17-30 April and all of our websites will be view only. For more information, read this Announcement

This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Installation of a generator for a house.

Hello all,


I'm moving house, (been here for over 42 years'!!), and one of the first items on my mind is installing an electrical generator.


SO; I guess there will be contactors / switch gear etc as I would like it to be 'automatic', (OR, maybe 'manual' too), changing from incoming to the generator.


a; What would be the best type of generator to purchase? Load wise? I'm not too worried as the bigger the load the bigger the           generator would need to be as long as I could run the basics within the house.


b; What switch gear would be appropriate?


I would't fancy the idea of switching tails around on a Henley block each time I needed the generator to be in use!!


Thanks, in advance!


regards... Tom
Parents
  • I suspect that the PSCC is irrelevant in the context of a 32A MCB as the genny will not be able to produce much more than  the rated current (8kW) so the wiring is protected by the generator output limit. A fault would still constitute a fire risk and shock risk but an RCBO should pick these up.

    More relevant may be whether a 6A MCB would trip.
Reply
  • I suspect that the PSCC is irrelevant in the context of a 32A MCB as the genny will not be able to produce much more than  the rated current (8kW) so the wiring is protected by the generator output limit. A fault would still constitute a fire risk and shock risk but an RCBO should pick these up.

    More relevant may be whether a 6A MCB would trip.
Children
No Data