Rules and Guidelines
Want to participate in the discussions? Please read our Community Rules and Guidelines. Need some help? Visit Support and Answers.

  • State Not Answered
  • Locked Locked
  • Replies 17 replies
  • Subscribers 31 subscribers
  • Views 5711 views
  • Users 0 members are here
Options
You may also be interested in
This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

Earth Bonding Gas & Water Pipes

AncientMariner
Assuming the copper water pipe (above the stop-cock at end of MDPE pipe) is close to the gas pipe, is it acceptable/permissible for the earth bonding conductor to be a single 10 mm² green/yellow from the consumer unit to go to say the water 351 earth clamp, looped around the screw and then to the gas 351?  This without cutting the cable, so that it is one continuous length. Or if not looped around the crew, for a bare section to be opened up 3 strands and 4 strands and the screw fitted between?
Thanks.
Clive

Parents
  • 0
    full 10mm around (approx 180 degrees) always.

    Even do that on last one (or the only one) unless using a eyelet crimp, kwick turn on end - prevents puill out on loose screw.
Reply
  • 0
    full 10mm around (approx 180 degrees) always.

    Even do that on last one (or the only one) unless using a eyelet crimp, kwick turn on end - prevents puill out on loose screw.
Children
No Data

Join us to get the best from IET EngX.

Joining EngX lets you personalise your experience so you stay up to date on the topics that interest you, plus you’ll be able to make connections who are looking to collaborate, exchange ideas and more.

Join us Not now

Community Rules & Guidelines