The IET is carrying out some important updates between 17-30 April and all of our websites will be view only. For more information, read this Announcement

This discussion is locked.
You cannot post a reply to this discussion. If you have a question start a new discussion

2 electricity supplies to one building

Former Community Member
Former Community Member
Hello, I am a not an engineer but need some advice on uk wiring regulations please. 

A national utility company is fitting a 32A charger in my garage for an electric vehicle. 

The garage is detached from my house but there is an existing circuit from the house consumer unit to the garage for lighting and a power socket. The cable runs along a garden wall. 

The new charger will have its own cable run from the same consumer unit in the house down to the garage. 

My problem is that the engineer who came to do the installation refused to do it as he said the garage is a building in its own right and regulations do not allow 2 supplies to one building.

My question is: Do 2 wiring circuits from the same consumer unit constitute 2 supplies If the consumer unit is located in an adjacent building? 

I would have thought that this was still a single supply and to have 2 supplies you need 2 separate meters with 2 consumer units which is not the case here but then, as I said, I’m no engineer. 

Edit.....The engineer stated that the regulation related to avoiding the risk of a voltage between 2 different earths. To me this again only makes sense if you were talking about 2 totally different supplies from different meters and therefore possibly different sub stations etc.
Parents
  • Former Community Member
    0 Former Community Member
    The main fuse, the meter, the henley block  and the consumer unit all say 100A on them


    That may well be, but what does your supplier say? Regulation 132.16 states that no addition or alteration, temporary or permanent, shall be made to an existing installation, unless it has been ascertained that the rating and the condition of any existing equipment, including that of the distributer, will be adequate for the altered circumstances.


    The main fuse feeding your "street" may be 400 A so what would happen if four of your neighbours did the same?


    Regards


    BOD
Reply
  • Former Community Member
    0 Former Community Member
    The main fuse, the meter, the henley block  and the consumer unit all say 100A on them


    That may well be, but what does your supplier say? Regulation 132.16 states that no addition or alteration, temporary or permanent, shall be made to an existing installation, unless it has been ascertained that the rating and the condition of any existing equipment, including that of the distributer, will be adequate for the altered circumstances.


    The main fuse feeding your "street" may be 400 A so what would happen if four of your neighbours did the same?


    Regards


    BOD
Children
No Data