This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wrong polarity on kitchen edison batten holders:Coding.

Doing a condition report where the diy tenant has gone mad with surface plastic conduit downstairs to

add extra light points to varius rooms.In the kitchen are 6 edison holders on ceiling besa boxes.Noticed polarity

was wrong on the 1st one checked.My 1st thought for a coding was C2,but the lamp would need removing to

expose the live terminals,the same as a bc lampholder,which has the same danger of touching live parts .So would C3 be more appropriate?The live terminal

contacts when the lamp is fully inserted.

                                                    Regards,

                                                           Hz
Parents
  • hertzal123:

    Many thanks for all the replies,its a long time since I,ve seen an E27 holder with a metal thread,come to think of it.

                                                                                                                            Regards,

                                                                                                                                   Hz




    Have a look on Fleabay

    f7a44a7011c2cbb6b2ccbbd50ea143e8-original-c18e8708-9c61-4404-a58e-86039b3fa315.png


Reply
  • hertzal123:

    Many thanks for all the replies,its a long time since I,ve seen an E27 holder with a metal thread,come to think of it.

                                                                                                                            Regards,

                                                                                                                                   Hz




    Have a look on Fleabay

    f7a44a7011c2cbb6b2ccbbd50ea143e8-original-c18e8708-9c61-4404-a58e-86039b3fa315.png


Children
No Data