This junction box has been installed by my builder's electrical worker, the void above the box is the ceiling space on ground floor
is this acceptable for residential installation?
This junction box has been installed by my builder's electrical worker, the void above the box is the ceiling space on ground floor
is this acceptable for residential installation?
Is somebody going to push down that half-open green lever?
Good spot!
The lever seems to be broken in the triplet left of it, but cpc and N: where is the line?
(Presumably, there was a CU up against the ceiling at one time.)
It gets better than that
Installer tried to cert that there was a pre-existing open circuit on the PE ring
This wasn't actually the connection causing the issue, these lever terminals suitable for 6 - 25 ², or the top connection might have just been clamped
The correction isn't much better
have to double check these connections too
It gets better than that
Installer tried to cert that there was a pre-existing open circuit on the PE ring
This wasn't actually the connection causing the issue, these lever terminals suitable for 6 - 25 ², or the top connection might have just been clamped
The correction isn't much better
have to double check these connections too
We're about to take you to the IET registration website. Don't worry though, you'll be sent straight back to the community after completing the registration.
Continue to the IET registration site