Why are different screw heads used in UK 3 pin plugs?

Hi Lisa, looking at your lower photo of the fuse side of the plug, note that the brown wire has been damaged by being "sandwiched" between the two case parts - ideally it would have been routed through the gap at contact level, going around rather than jumping over  the angled chicane. That mini-maze feature to the moulding is designed to ensure that wires cut to the same length don't pull-out in the wrong order leaving live connected but neutral pulled out, by using up the extra length saved  from the fuse compared to a direct to pin connection. 

Ideally when someone trips on the lead, hard enough to tug through the cord grip (harder these days than on the early plugs) the live breaks first ! There is also something a bit odd about the grommet anti-kink tail and I think that is supposed to be pinched inside the body, and the wire generally pushed up further through the cord grip bar to allow this. 

That said, as its a low current appliance and it is presumably running perfectly well it's not worth worrying about enough to open it up to change it specially, presumably although the insulation is displaced the core strands remain are intact and are not actually exposed,  but it is a thing worth looking at if it fails in the future. It may also mean the back is not fully seated.

In any case something to  watch for, when fitting plugs in the future. 

Best Regards Mike.

Hi Mike

Yes I spotted that when I took the back off the plug!

Also the screw for the earthing cable contact was actually loose in the plug too so I popped that back in!   Given that neither myself or my partner had opened up that plug since it was purchased around 4 years ago it was obviously quite a shoddy manufacturing assembly! 

Anyway... it's all a bit immaterial now as I managed to snap one of the fan blades whilst trying to straighten it out so the whole thing has gone in the bin 

Hi Mike

Yes I spotted that when I took the back off the plug!

Also the screw for the earthing cable contact was actually loose in the plug too so I popped that back in!   Given that neither myself or my partner had opened up that plug since it was purchased around 4 years ago it was obviously quite a shoddy manufacturing assembly! 

Anyway... it's all a bit immaterial now as I managed to snap one of the fan blades whilst trying to straighten it out so the whole thing has gone in the bin 

Lisa Miles said:

since it was purchased around 4 years ago

New or, as they say nowadays, "pre-owned"?

It has been 32 years since appliances had to be fitted with a plug https://www.legislation.gov.uk/uksi/1994/1768/regulation/12/made, but I would have expected a moulded plug 4 years ago.

Definitely 'new' Chris! Bought it from one of the big supermarkets.... and not the cheap ones either... 

Depends where on the planet the plug was put on, in terms of the labour cost of fitting it, and how big a fraction of that maker's market is in the UK to justify the investment in making leads with moulded plugs for just one destination's rather odd (if technically superior) square pin plug.

Compared to the mainland Europe, we are a small market. (and the low  current (2.4A 4mm pins) Europlug with the slightly inward sprung pins fits a 13A socket anyway, with the aid of a biro to open the shutters. Sadly its not fused when doing that and not really very safe.)

Mike