AFDD

Albert Law said:

Is it proven on enhancing electrical safety and is it worthwhile on the additional cost involved ?

To the best of my knowledge, the UK does not record fire safety statistics for electrical installations to an appropriately granular level to assess this properly.

Hi Gkenyon!  

Thank you so much for your kind response.

In Hong Kong, we are preparing to use AFDD on a wider scale but we find it difficult to justify the very high cost involved.

I would suggest that some universities in the UK or other countries will carry out research on the justification of application of AFDD in collaboration with the major manufacturers of AFDD.

Albert Law said:

I would suggest that some universities in the UK or other countries will carry out research on the justification of application of AFDD in collaboration with the major manufacturers of AFDD.

If there is a driver to do so? I have not come across any, but I guess an internet search would reveal any prior or in progress research if you are looking for that?

USA was first to implement, so if there is any data, it would be there.

Its not what you want to read I suspect but a few years ago now a chap from CIBSE did some independent experiments and analysis It seems that his paper has now escaped onto the internet, so I link to it here  Arc Fault Devices Are they worth it?

His conclusion was as above that there  is not really a lot of evidence. Actually the conclusions are more than equivocal about the claimed 'advantages', and sort of suggests that at best they only detect a very limited range of dangerous situations, (".. verification tests are quite artificial, and there appears a disconnect between  BS EN 62606’s verification procedure and real faults..") and comments that in terms of fire safety we'd probably do better replacing PVC with XPLE cable... Apart from that it is a pretty ringing endorsement. Ha !

Mike.

Ideally, a randomised controlled trial is required. So take a new development and randomly assign 50% of dwellings to get AFDD and 50% not.

Then observe. Given the rarity of electrical fires, even with a whole new town, it might take a long time.

If anything less than a randomised controlled trial is performed, it is going to be difficult to exclude obviously biassing factors. So, installations with AFDDs will be newer than those without, the owners/occupants may be more risk averse and use other means to reduce the risk, and so on.

mapj1 said:

Its not what you want to read I suspect but a few years ago now a chap from CIBSE did some independent experiments and analysis It seems that his paper has now escaped onto the internet, so I link to it here  Arc Fault Devices Are they worth it?

Given the current thread debating the merits of the ring final circuit, makes an interesting point about the ring removing the voltage difference across a conductor break, so preventing series arcing faults.

mapj1 said:

Its not what you want to read I suspect but a few years ago now a chap from CIBSE did some independent experiments and analysis

I've definitely read this? (Although mapj1  I understand if this wasn't aimed at me, just the post said 'in reply to gkenyon ')

I'm also not sure it's correctly attributed to CIBSE affiliation ?

Happy to let everyone draw their own conclusions ... but at the end of the day, I'm firmly of the opinion that any comments about the performance, operation, relevance or need for the device ought to be aimed at BS EN 62606 and IEC 62606 ... BS 7671 is not, after all, a product standard (and nor is IEC 60364 series).

gkenyon said:

Happy to let everyone draw their own conclusions ... but at the end of the day, I'm firmly of the opinion that any comments about the performance, operation, relevance or need for the device ought to be aimed at BS EN 62606 and IEC 62606 ... BS 7671 is not, after all, a product standard (and nor is IEC 60364 series).

BS 7671 is stipulating that AFDDs "shall" be used in some situations and generally "recommended" in other situations (421.1.7).

This is a moderately serious regulatory intervention, directly changing wiring practices with direct financial costs being imposed on the end-consumer.

To state the obvious, there must be some evidence base, a safety incident analysis, a cost-benefit calculation to justify the imposition of this requirement. 

Presumably the committee responsible for deciding to add that requirement into the BS 7671 must have that evidence and analysis, does anyone know where that is recorded? 

Apologies for any confusion Graham, that was supposed to be a reply to Albert's main request for supporting evidence, not to you in particular - that is just a mixture of my fumble fingers and a counterintuitive  software feature. My slightly odd turn of phrase is because I had already seen a copy of that article some time ago, as a private communication, but only now realised it was now on the web, and so I felt I could therefore mention it.

But there is a second serious point.

I am reminded that back when RCDs first came into common use and long before they first got snuck into the regs and then only for sockets that might be used to supply equipment outdoors, there were a whole rash of newspaper and tragic That's Life style  reports to encourage us to use them of the form ' boy saved from cut lawnmower lead by new safety device'; 'disaster averted', 'life could have been saved' ' tragedy in the sun' Sun says 'whew what a scorcher'  etc.

Far more recently, prior to the changes about cables remaining supported in fires driving the installation of metal clips and so on, there were several reported cases of folk becoming entangled in fallen wiring during fires and rescue attempts, and nasty injuries or deaths occurring that could have been fewer or maybe even avoided altogether as supporting evidence that the changes were proportionate.

Comparatively any equivalent reporting has been very quiet on the AFDD front, even in North America where the things originated, and the UK regulatory requirements rather appear to have preceded the body of evidence. 

Mike. 

It seems to me that an engineer can demonstrate in the lab that an AFDD does what it is intended to do during product development, but that is very different from demonstrating that they can save lives or property.

Along similar lines, a statin can be shown to reduce harmful lipids in the blood, but evidence of added quality adjusted life years could only emerge after they had been in extensive use for a number of years.

TurboGen said:

This is a moderately serious regulatory intervention, directly changing wiring practices with direct financial costs being imposed on the end-consumer.

It's definitely not a 'regulatory intervention' ... that would require legislation!

TurboGen said:

To state the obvious, there must be some evidence base, a safety incident analysis, a cost-benefit calculation to justify the imposition of this requirement. 

Presumably the committee responsible for deciding to add that requirement into the BS 7671 must have that evidence and analysis, does anyone know where that is recorded? 

All I can say to that, is that it's been through public consultation (multiple times) and rigorous debate ... I've added something to a subsequent reply that might be of interest, that is in the public domain.

TurboGen said:

This is a moderately serious regulatory intervention, directly changing wiring practices with direct financial costs being imposed on the end-consumer.

It's definitely not a 'regulatory intervention' ... that would require legislation!

TurboGen said:

To state the obvious, there must be some evidence base, a safety incident analysis, a cost-benefit calculation to justify the imposition of this requirement. 

Presumably the committee responsible for deciding to add that requirement into the BS 7671 must have that evidence and analysis, does anyone know where that is recorded? 

All I can say to that, is that it's been through public consultation (multiple times) and rigorous debate ... I've added something to a subsequent reply that might be of interest, that is in the public domain.