Am I correct in simplifying a ring circuit like this in theory? Assuming the loads are the same 1ohms and the distance between each load is the same as well.
Am I correct in simplifying a ring circuit like this in theory? Assuming the loads are the same 1ohms and the distance between each load is the same as well.
Does anyone know what the OP's diagram has to do with 'simplifying'?
Does anyone know what the OP's diagram has to do with 'simplifying'?
I imagine the red lines represent low resistance current paths that are in fact made of insulated metal wire and are much longer , and far more convoluted, than on the diagram, and A denotes current in amps flowing in a line adjacent to the letter. There is the complication that if that is true it depicts a centre fed radial, not a ring, and the layout and choice of letters is unusual, but not impenetrable.
I'd be the first to agree it is not a standard schematic diagram to BS3939 nor the ISO standard for that matter.
Mike
We're about to take you to the IET registration website. Don't worry though, you'll be sent straight back to the community after completing the registration.
Continue to the IET registration site